Motor unit E / Arm E95P
(drawing 1) |
Motor unit E / Arm E95F
(drawing 2) |
 |
 |
|
|
|
|
Motor unit E dimensions |
|
|
|
|
|
|
|
|
Windscreen wiper choice
(with reference to drawings 1
and 2) |
|
|
Please
find below the schedules showing the wiper arm to be used
(pantograph dark squares, pendulum clearly squares) on the basis of
the window dimensions. Before to use the schedules, you have to
decide the distance C between the hole for the motor axle and glass
edge. The first schedule is calculated for C=100mm, the second for C=50mm and the third for the motor directly installed on the glass. In the square where the row and the column, indicating height and width of the glass, cross each other, you can find the best arm lenght (P for Pantograph, F for Pendulum), wiping angle and blade lenght. |
|
Measure C = 100mm +/- 20mmPlease use the same equipment indicated in the last square of the row. 
Measure C = 50mm +/- 20mmPlease use the same equipment indicated in the last square of the row. 
Installation on glass at 50mm from glass rimPlease use the same equipment indicated in the last square of the row.
|
|
|
|
|
|
Wiping angle set up |
|
|
Standard angles are : 45° 60° 80° 110° Other four angles ( 50° 70° 90° 100°) can be obtained changing the angle plate in the motor with the supplementary angle plate you can find in the motor package. |
|
|
|
|
|
Adjustment of arm length |
|
|
The arm is supplied with length 550mm. It's possible to adjust arm length up to 280mm |
|
|
|
|
|
Motor unit positioning |
|
|
Motor units can be installed
above or below the windscreen. It is important to respect the distance
(C) between the axle hole and the glass rim that was used to calculate
and choose the arm length of the wiper. The picture above show the correct mounting for 16mm axle hole that must be perpendicular to the windscreen surface, using a wedge when necessary. The motor axle must protrude by 28 - 35mm, if it protrudes more it is necessary to position a packing block between the motor and the wall. |
 |
|
|
|
|
Electric wiring |
|
| Below you can find the schematic diagram to connect the motor to the line. |
 |
|
|
|
|
© copyright 2003 Speich s.r.l. |
|
