The control panel UCS is
available to drive one or two wiper motors and up to three auxiliaries
devices. The electronic part is placed inside the control panel housing.
On the rear part of the panel are located the terminals for the
electrical connection.
Following IEC 61554, three different panel sizes are available depending
on the chosen model (see drawings below): 96x72 - 96x96 - 96x144, all of
them with 165mm depth.
Suitable for windscreen wiper systems SPEICH type: M, S, SF, PG
Able to drive the wiper motors independently or/and in group mode
Wiper working mode: continuous or intermittent with variable delay (between
3 to 9 seconds).The intermittent working is synchronized for all
switched on wiper motors
Motors overload protection
Custom made panel layout
Technical features
Voltage
Wipers systems type driven No.
of driven wipers
Auxiliares
Working mode
Interval mode
Motor thermal protection
Electronic
24 - 110 - 220 V
One speed motor type M - S - PG
1 - 2
0 - 3
Continuous and interval mode
Synchronized
On the panel
Inside panel
Available models
Example
Code: UCS.1
(96x72 deph 165)
Code: UCS.12SH
(96x96 deph 165)
Code: UCS.2
(96x96 deph 165)
Code: UCS.22SH
(96x144 deph 165)
Auxiliaries switches
Auxiliaries switches can
be composed following installation needs.
Above drawings and their codes are only an example.
Washing system
Purge air electrovalve
Wiper housing heating
Heated arm
Heated glass
Code
Above you can find how to
compose the panel code. For the order it is also necessary to advise the
voltage.
Our technical department is always available to help you to make your
choice.
Technical features
Washing system
Purge air electrovalve
Wiper housing heating
Heated arm
Heated glass
