Voltage: 12 - 24 V
For single speed motors
Synchronized
movement of motor units
Windscreen washer system switch Can drive
from 2 to 5 windscreen wipers simultaneously Small
sized panel
With PNS control panels it's possible to drive from 2 to 5 wiper
motors with synchronized movement.
On the panel you can find the main switch to start all the motors
together; it's then possible to change the working mode choosing
between interval delay or continuous movement.
Single wipers can be switched on and off as necessary.
This is also a button used for the operation of the
washing system.
All models operate with 12 -
24 V. Note: all motor movement is synchronized both in the interval
and continuous working mode.
1)
To turn on all wiper motors together, push the ON/OFF button: the
wiper system starts to work in interval mode.
2)
Each wiper motor can be switched on or off using the relative button.
Note: the movement of motors in operation is always synchronized both in
interval and in continuous mode.
3)
The same buttons are used to select between four different delay
intervals and continuous operation.
4)
The WASH push button switch on all wiper motors actuates the
fresh water pump or electrovalve used to feed water spray nozzles.
After releasing the WASH button, the wipers make still some strokes
before stopping.
The system is composed of a small sized soft-touch panel
which installed on the console and a two meter cable which connect the panel to
the
elctronic unit.
The installation is completed by connecting the mains and individual
motors to the unit.
To install the control panel, make an opening with dimensions as per
the
hatched area.
The panel is fixed to the console with four screws.
Technical features
Voltage: 12 - 24 V
