The modular wiper control
system consists of two basic components: the control panel
(LMS.E) and the power module (LMS.P). The power module is able
to drive up to three wiper motors. The panel is connected to the
first power module with an RJ12 cable and it is then possible to
connect together, always with an RJ12 cable, up to three power
modules.
Please find below two example that show how to connect 3 and 5
wiper motors. The 5 wiper motors system needs two power modules
and wiper switch 1 operates wiper motors 1 and 2, switch 2 the
wiper motor 3 and switch 3 wiper motors 4 and 5.
Note: it is also possible to install a second control panel to
operate the wiper system from different positions.
Example 3 wipers (1 Panel LMS.E - 1 Power module LMS.P)
Example 5 wipers (1 Panel LMS.E - 2 Power modules LMS.P)
Installation
To install the control panel on the
consolle it’s necessary to make an opening of 75mm diameter.
The panel is supplied with a 5m long RJ12/6poles cable to connect it
to power module. On request we can supply 10m long cable.
Electrical connections to the line and to the motors are made on the
power module by means of 6.3mm Faston contacts.
Technical features
Voltage: 12 – 24 V DC Max current for each motor output:
10A Washer output: 5A Each wiper separately fused at 10A Able to drive two speeds motor Soft touch control panel High and low continuous running Interval Intelligent wash & wipe program Washer liquid level alarm Solid state power electronics
Note: wipers synchronized at all speeds
Modular wiper control LMS
(from 3 up to 9 wipers)
Voltage: 12 – 24 V DC